Connecting The Unit To The Water Network - S&P UTBS Serie Manual De Instalación. Instrucciones De Uso

FUn
FUn
FUn
FUn
Enter the rated values from the name plate for the motor used in the parameters shown in
the table below:
WARNING: where using a single frequency inverter to control two motors,
Menu
drC
drC
drC
drC
drC
drC
Finally again press "ESC" for two seconds until the 3 indicator LEDs light sequentially to
return to RUN mode (automatic frequency inverter operation mode).

6.8. CONNECTING THE UNIT TO THE WATER NETWORK

- Maximum pressure : 31,62 bar
- Maximum temperature: 150ºC
• For heat exchangers with threaded connections, secure the coil manifold with the appro-
priate tool when tightening the threads. This will prevent the force from being transmitted
to the manifold, which can damage it.
PI
PI
StC
AdC
double the value of the rated current "nCr"
Parameter
bFr
UnS
FrS
nCr
nSP
COS
PII
rPI
Stt
AdC
Rated frequency of the fan
Rated voltage of the motor as shown
on the name plate
Rated frequency of the motor as shown
on the name plate
Rated current of the motor as it appears
on the name plate
Rated speed of the motor as shown
on the name plate
Cosine of the phase offset angle of the motor as
shown on the name plate
63
YES
50,0
nSt
nO
Notes