Bosch HDS252U Instrucciones De Instalación página 3

WARNING
RANGE TIPPING HAZARD
® Ailrangescantipandinjurycouldresumt.Toprevent
accidental tipping oftherange,attach it tothe floorby
installing the Anti-Tip Device supplied,
o A riskoftip-over may exist if the applianceis not
installed i naccordance with these instructions,
®
Install a nti-tipdevice p acked with range.
® If the range is pulled away from the wall for
deaning, service, oranyother reason, ensurethatthe
Anti-Tip Device is properly reengaged when the range
ispushed backagainstthewaH, Intheeventofabnorma_
usage (such as a person standing, sitting, or meaning on
an open door), failure to take this precaution could
resumt in tipping of the range. Personal injury might
WARNING
BeforeinstaHing_turn powerOFFat
theservice panel, Lockservice panel
to prevent power from being turned
L ON acddentaHy. .._,
CAUTION )
Unit is heavy and requires at meast |
two persons or proper equipment |
to move. J
For Massachusetts Installations:
1, Installation must be performed by a qualified or
lisensed contractor, plu tuber or gas fitter qualified or
licensed by the state, province or region where this
appliance is being installed.
2. Shut-offvalve must be a "T" handle gas cock.
3. Flexible gas connector must not be longer than 36
inches.
J
HIGH ALTITUDE INSTALLATION NOTE;
Forinstallation ataltitudes above 2,000ft., contact Bosch
Service (800-994-2904) for special instructions.
IMK)RTART:
LOCAL CODES VARY, INSTALLATION, ELECTRICAL
CONNECTIONS AND GROUNDING RUST CORPLY WITH ALL
_pucsUBm _= CODES.
, Proper Installation - Be sure your appliance is properly
installed and grounded by a qualified technician in accordance
with the National Electrical Code ANS]:iNFPA No. 7 latest edition
and local electrical code requirements.
This appliance has been tested in accordance with ANSI Z2!. !,
Standard for Household Cooking Appliances (USA) and in ac-
cordance with CAN !.1qVl81 Interim Reqt #58 Domestic Gas
Cooktops (CANADA).(I:n Canada, installation must be in accor-
dance with the CAN !-B!49.! and .2 Installation Codes for Gas
Burning Appliances and/or local codes)
]:t is recommended that the range be used in conjunction with
a suitable ventilation system.
The following must be met when testing supply piping system:
a) The appliance and its individual shut-offvalve must
be disconnected from the gas supply piping system
at test pressures in excess of !/2 psig (3.5 kPa).
b) The appliance must be isolated from the gas supply
piping system by closing its individual manual shut-
offvalve during any pressure testing of the gas sup-
ply piping system attest pressures equal to or less
than !/2 psig (3.5 kPa).
Avoid drafts across the range. They will obstruct ventilation and
combustion.
Never modify or alter the construction of a range by removing
leveling legs, panels, wire covers, antFtip brackets/screws, or any
other part of the product.
Notice: DO NOT L_FT RANGE BY DOOR HANDLE, Remove the
door for easier handling and installatiom See Section 'Removing
Oven Door' in Use and Care manual.
Page 2