Danfoss RET1001M-V2 Guia De Instalacion página 4

Installation Guide
1. Installation Steps
EN
1. Installation must be done by an authorised
electrician.
2. The room thermostat should be installed at
approx. 1.5 m above oor and where the e ects of
sunlight, draught or other heat sources (eg. TV's)
are avoided, see g. 1. on page 44.
3. First loosen lower retaining screws and carefully
remove back plate, see g . 2 on page 44.
4. Mount back plate direct to wall or on wall box and
wire according to application, see g. 3 on page 44
& g. 5 on page 45 according to application.
5. Locate hooks at top of front part into top of back
plate and lower into position and tighten retaining
screws.
2. Dimensions and Wiring
See g. 4 for dimensions and g. 5 for wiring
diagram on page 45.
3. LED indicators
Power on - Green
Thermostat Output on - Red
4
RET1001M - V2