Retekess T130S Manual Del Usuario página 5

F.Put the receivers in the power-on state close to the transmitter (within about 2
meters), the receivers will receive sync signal. Once sync successfully, the
receivers channel will be changed to the same channel as the transmitter
G.Press the ( ) button on the transmitter to exit channel synchronization mode.
Receiver
1.Power on and power off
Power on: Press and hold (
to power on.
Power off: Press and hold (
power off.
2.Volume Setting
In working mode, press (
adjust the volume (the value could be set from 0 to
9 level).
Note: Volume cannot be adjusted while the receiver
is in signal seek mode (
receiver screen.
If you use T130s transmitter with the old version
T131 receivers, you need to use the following
method to set the channel ID.
1.Wireless Channel Synchronization Setting
Transmitter Setting
A.In the power off mode, press and hold (>) button
by your left hand, then press (
by your right hand
B.Release the (
C.Release the (>) button when the channel ID flashed on the screen, the
transmitter enters channel setting mode
D.Press (>) or (<) button to select the desired channel
E.Press ( ) button to confirm, the transmitter enters the wireless channel
synchronization mode
Then Set the Receiver
F.In power off mode, insert the earphone, press and hold the (
your left hand, then press the (
receiver.
G.Release the (
H.Release the (
screen, the receiver will receive sync signal. Once sync successfully, the
receivers channel will be changed to the same channel as the transmitter ( Note:
this step must be done under the condition that the transmitter is at the wireless
channel synchronization mode)
I.Turn off the transmitter, then turn on it, the transmitter will work with the paired
receivers.
) button for 1 second
) for 1 second to
) or (
icon shows on the
) button for about 2s to turn on the transmitter
) button when the transmitter is powered on
) button with your right hand to turn on the
) button when the receiver is powered on
) button when the channel ID shows 00 in the receiver
) button to
2
) button with