Publicidad
Idiomas disponibles
Idiomas disponibles
TOOL REQUIRED: PHILLIPS SCREWDRIVER
Belt part # 3-91 0340-600, is located on the side of cleaner.
I
BELT STYLE: 12
1
Loosen the one (1) screw
Gently lower filter cover from
Belt is stored on the inside of the
Replace filter cover. Secure
located at the top of filter cover.
body.
filter cover on top. Remove and
the one (1) screw at the top of
replace with another NEW belt.
filter cover.
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG CLEANER BEFORE CHANGING BELT OR BRUSHROLL.
Flip cleaner to expose nozzle
Lift and remove brushroll.
Slide old belt off motor shaft.
Place belt on motor shaft, then
base. Base should lay flat and
Dispose of old belt.
slip brushroll through belt.
face up. To remove nozzle
Place belt in area of brushroll
guard, use Phillips screwdriver
without bristles.
to remove the six (6) screws.
Arrows
show
location
of
screws. Lift nozzle guard off.
With belt in place, pull and
Reattach nozzle guard. Secure
slide brushroll into nozzle mak-
by replacing the six (6) screws.
ing sure that the brushroll end
caps are in the correct orienta-
tion (5a). IMPORTANT: Rotate
brushroll manually to make
sure belt is not twisted.
8
Publicidad
