EDIFIER HECATE GT4 Manual Del Usuario página 3

■ Take earbuds out
For initial use, take the earbuds out of the charging case and tear off the protective films on them.
Then place them back into the case and take out again, they will power on and start searching for
Bluetooth devices.
■ Charge
For initial use, place the earbuds in the charging case and close the case, then connect the case
to power source with the included charging cable for charging.
Rated input: 5V 40mA(earbuds)
Charge the
earbuds
Charge the
charging case
Open/close the
charging case
Warning: The rechargeable batteries that provide power for this product must be disposed
properly for recycling. Do not dispose of batteries in fire to prevent an explosion.
If it is not used for long periods of time, please charge the product with lithium battery every three
months.
Do not use a high-power charger to charge the product for avoiding product damage.
Place the earbuds in the
case, and the case will
auto-charge the earbuds.
Connect the case to power
source with the included
charging cable for charging.
5V 400mA(charging case)
Charging: The ice blue lights of the earbuds
flash in a breathing pattern.
Fully charged: The ice blue lights of the earbuds
will be lit for 5 seconds and then turn off .
Charging: the red indicator flashes in a
breathing pattern;
Fully charged: the red indicator turns off.
Open the case: RGB light effects vary gradually.
Close the case: RGB light effects vary gradually.