Radioddity PR-T6 PMR EU Manual Del Usuario página 5

process, as well as the red led will be on on the desktop charger.
Installing and Removing Belt Clips
With the belt clip, you can easily attach the radio to the belt. However, the belt clip must be removed to install or
replace the battery.
To remove the belt clip, follow the illustration. Fasten the clip into the slot on the unit in the radio's rear rail until it
snaps into the square.
Removing/Installing the Battery Pack
• Remove
1) Remove the belt clip as previously described.
2) Open the battery compartment as shown in the figure;
3) Remove the battery pack from the device;
4) Snap the belt clip back into place.
5) Close the battery compartment with the cover and put the belt clip back in place.
• Install
1) Remove the belt clip as described in the previous
paragraph.
2) Insert the battery pack into the appropriate compartment
of the device.
3) Close the battery compartment with the cover and put the
belt clip back in place
Main controls and parts of the radio
1. Antenna
2. LCD Display
3. UP button - Press to increase the volume. Menu mode to change
settings in MENU.
4. /MENU- Press this control to enter the radios MENU. If you keep
it pressed for about 3 seconds, the keypad lock is activated.
5. /CALL - To send a call to the selected channel. keep pressed to
turn on/off the radio.
6. DOWN button - Press to reduce the volume. menu mode to
change settings in MENU.
3