Descargar Imprimir esta página

Troy-Bilt Bronco Manual Del Operador página 9

Ocultar thumbs Ver también para Bronco:

Publicidad

Idiomas disponibles

Idiomas disponibles

3.
Slide the wheel
fully inward
on the wheel shaft.
Reinstall
the wheel drive pin through
the wheel shaft only (not
through
the wheel
hub). See Fig. 3-5. The wheel should
now spin freely (freewheel)
on the wheel
shaft. Repeat with
the other wheel.
4.
Use the handlebar
to roll the tiller to a flat area.
NOTE: Before starting
the engine, the wheels must be placed
in
the WHEEL DRIVE position
(pins through
wheel hubs and wheel
shaft).
Forward ClutchCable
1.
Carefully
unwrap the forward
clutch cable from its shipping
)osition.
Pull the cable up through
the bottom
hole of the
cable bracket and push the cable connector
up through
the hole until the groove in the connector
snaps into place.
See Fig, 3-6.
Z=Connector
.............
2.
Figure 3-6
Place the Z-connector
into the hole in the forward
clutch
bail from the outside
of the bail to the inside. See Fig. 3-6.
ReverseClutchCable(If s0 equipped)
1.
Carefully
unwrap the reverse clutch cable (Red end fitting)
from its shipping
position.
Pull the cable up through
the
top hole of the cable bracket and push the cable connector
up through
the hole until the groove in the connector
snaps into place. See Fig. 3-7.
Z=Connector
2.
Figure 3-7
Place the Z-connector
into the hole in the reverse clutch
handle assembly
from the inside of the handle to the
outside.
See Fig. 3-7.
Set-tip
TirePressure
Check the air pressure with a tire gauge. Deflate
or inflate the
tires equally to between
15 and 20 PSI.
NOTE: Be sure that both tires are inflated
equally
or the tiller will
pull to one side.
Gas& Oil Fill Up
WARNING!
Use extreme
care when handling
gasoline. Gasoline
is extremely
flammable
and the
vapors are explosive.
Never fuel the machine
indoors or while the engine
is hot or running.
Extinguish
cigarettes,
cigars, pipes and any other
sources of ignition.
Service the engine
with gasoline and oil as instructed
in the
Engine Operator's
Manual packed separately
with your tiller.
Read the instructions
carefully.
SECTION
3 -- ASSEMBLY& SET-UP
9

Publicidad

loading

Este manual también es adecuado para:

Super broncoPro-line crt