ii ! !!illi i ! i !i iiiiii !sii :!iiiii i i ! i ! i i iiii!i! l iiiii!l ! iiii!!i ; iiiii; i iiiiiii !
INSTALLING AND CARING FOR FILTERS
Electrical Shock Hazard
Disconnect power before removing filters.
Replace all panels before operating,
Failure to do so can result in death or
electrical shock,
The grease (aluminum) filters should be removed
and cleaned often, at least once a month.
You can order replacements (Part No. 8184001)
from your nearest Sears Service Center.
The 3M charcoal filter cannot be cleaned and
should be replaced every 6 to 12 months.
NOTE: Your microwave hood combination
comes
with the 3M charcoal filter (Part No. 8184019)
installed behind the vent grille.
1, Unplug microwave oven or disconnect
power.
2, To remove the grease filters (aluminum), push
each filter up on the
side opposite the tab.
Grasp the tab and slide
the filter to the side.
Pull the filter down-
ward. It will drop out.
3, Soak grease filters in hot
•
DISHWASHEP
CLEANER
_
_
water and a mild deter-
gent. Scrub and swish to
remove embedded dirt
and grease. Rinse well and
shake to dry. Do not use
ammonia, corrosive
cleaning agents such as
lye-based oven cleaners,
or place in a dishwasher.
The filter will turn black
or could be damaged.
4.
To replace the grease filters, slide each filter
into the outer side of
the filter opening. Make
sure you are sliding in
the side of the filter that
does not have the tab.
Hold the tab with your
other hand. Push up the
tab side of the filter and
slide the filter to the
other side of the open-
ing to lock into place.
5. To remove the 3M charcoal filter, (located
behind vent grille) tilt
the grille forward, then
lift out to remove.
Grasp charcoal filter
and lift up and out of
slot.
6.
To replace the 3M charcoal filter, place new fil-
ter in slot and replace
vent grille by snapping
it into place.
NOTE: See edge of
charcoal filter for cor-
rect orientation.
7. Plug in microwave oven or reconnect power.
i
NOTE: Do not operate the vent fan without the
grease filters in place.
34