GIA OEM3 Manual De Usuario E Instalacion página 58

• Wire connection
1.Indoor unit (fig.12)
⚫ Open the panel upwards and open directly to the maximum.
⚫ Open the electrical cover.
⚫ Secure the connection wires to the terminal block according to the
wiring diagram on the electrical cover.
⚫ Press the connecting wire tightly with the pressure plate.
⚫ Close the electrical cover, secure the electrical cover with screws, and
close the panel.
Note: Some models may not be able to directly pass through the cable
hole into the electric control box, and the above steps need to be
removed after removing the middle frame.
1.Outdoor unit (fig.13)
⚫ Unscrew the handle cover fixing screw and open the handle cover.
⚫ Secure the connection wires to the terminal block according to
the wiring diagram on the handle cover.
⚫ Press the connecting wire tightly with the pressure plate.
⚫ Put the handle cover back and fasten with the screws.
⚫ If customers need to extend or replace the power cord, please
refer to Table 3 for specifications.
Table 3
5K/7K/9K/12K
16K/18K
21K/24K/28K/30K/36K
9K/12K（115V）
INSTALLATION MANUAL
Power
connecting wires
Max Length 10m
≥1.0mm²
Cross sectional
≥1.5mm²
area
≥2.5mm²
≥1.5mm²
Screw
Power cord
5m
≥1.0mm²
≥1.5mm²
≥2.5mm²
≥1.5mm²
24
Electric cover
Wiring diagram
Open
Close
Fig 12
Handle cover
Wiring diagram
Fig 13