Descargar Imprimir esta página

Skil PI0300C-00 Manual Del Propietário página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
WARNING
charger in fluid or allow a fluid to flow inside them.
seawater, certain industrial chemicals, bleach or bleach-containing products, etc. can cause a
short circuit.
WARNING
modification is misuse and could result in a hazardous condition leading to possible serious
injury.
INSTALLING/REMOVING BATTERY PACK (Fig . 2)
NOTE: Fully charge the battery pack before
first use.
To install battery pack
Align the mounting slots on the power inverter
with the ribs on the battery pack, then slide the
battery pack until it snaps into position on the
power inverter.
WARNING
into place and the battery pack is secured to
the power inverter before beginning operation.
Failure to securely seat the battery pack could
cause the battery pack to fall out, resulting in
serious personal injury.
To remove battery pack
Hold the battery pack with one hand and pull the power inverter with the other hand to
separate them.
WARNING
could result if the battery pack falls. NEVER remove the battery pack at a high location.
WARNING
TURNING POWER INVERTER
ON/OFF (Fig . 3)
1. Install the battery pack.
2 . To turn the power inverter on, press the
power button and the button will illuminate
green, which indicates that the power
inverter is activated.
3 . To turn the power inverter off, press the
power button again and the green light
will turn off, which indicates that the power
inverter is deactivated.
10
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your power inverter, battery pack, or
Do not attempt to modify the power inverter or create accessories not
recommended for use with this power inverter .
Make sure that the latch on
the power inverter snaps
Always be aware of location of your feet and children or pets around you
when separating the battery pack from the power inverter. Serious injury
Always remove the battery pack when the power inverter is not in use.
Corrosive or conductive fluids, such as
Fig . 2
Mounting
Slot
Fig . 3
Power Button
LED Button
Any such alteration or
Rib
LED Light

Publicidad

loading