Publicidad
Idiomas disponibles
Idiomas disponibles
LED LIGHT (Fig . 3)
The power inverter is equipped with one LED light integrated into the carrying handle. The
light provides illumination in low light conditions or serves as an emergency light beacon.
The LED light could be turned on whenever the power inverter is activated or deactivated.
To turn the LED light on, press the LED button. The light will turn on in low brightness
▘
mode.
Press the LED button again to switch to high brightness mode.
▘
Press the LED button the third time to switch the LED light off.
▘
In any mode, press and hold the LED button for more than 1 second and the light will
▘
switch into flashing, "EMERGENCY" mode. Press the LED button again, the light will shut
off.
POWERING EXTERNAL DEVICES
1. Install a battery pack onto the power inverter.
2. Press the power button to turn on the power inverter. The LED in the power button will
glow solid green, which indicates that the power inverter is ready for supplying power.
3. Connect devices to the power inverter's USB ports and/or 120V AC output port. The
inverter will begin powering the devices automatically.
4. When the power inverter is not in use, disconnect devices from the power inverter, then
press the power button to turn off the power inverter.
5. Remove the battery pack from the power inverter.
STATUS INDICATOR
Power Button LED
Indicator
Solid green
Flashing green (1
flash every second)
for 1 minute, then
shuts off
Solid red for 1 min,
then shuts off
Working Condition
Standby
The connected USB
device(s) draw(s) no
more than 2W and the
connected AC device
draws less than 5W.
Powering connected
devices.
Low battery voltage
The power inverter
or battery pack is
overheated.
Action
Normal operation. The
power inverter will shut
off automatically in 2
hours if there is no device
connected.
The power inverter could
still power the devices but
will shut off automatically
in 2 hours. If this happens,
turn the power inverter
back on.
Normal operation.
Charge the battery. See
"LOW BATTERY PACK
CHARGE PROTECTION"
below.
Allow the unit to cool
down, then restart the
power inverter. See
"OVER TEMPERATURE
PROTECTION" below.
11
Publicidad
