Publicidad
Idiomas disponibles
Idiomas disponibles
FUNCTIONAL DESCRIPTION
1
12
1. Blade cover
2. Support blade
3. Cutting blade
4. Extension coupler
5. Strap bevel
6. Hand grip
7. Lock-off trigger
8. Impact guard
9. Handle
10. Trigger
11. Branch hook
12. Shoulder strap
2
3
11
4
5
6
10
7
9
8
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove the battery pack
WARNING
any time the tool is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Removing/Installing the Cutting Blade
Replace the blade when it becomes dull or chipped.
A blade is dull when the blade edge appears rounded
or damaged.
Use only MILWAUKEE blade Cat. No. 48-44-2770.
Blade is sharp. Keep hands away
DANGER
from cutting edge. Laceration can
occur.
1. Close the blades. The cutting edge of the blade
should be covered by the lower jaw.
2. WARNING! Remove battery to avoid starting the tool.
3. To remove blade, use a scrench to first loosen
the T25 screw, then the 13 mm hex head screw.
13 mm hex
head screw
T25 screw
4. Remove the T25 locking cap screw.
T25 locking
cap screw
5
Publicidad
