Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
5
Installing the motor assembly
□
Remove two of the four screws (located diagonally from
each other) (NN) from the top of the mounting plate (A) and
loosen the other two screws (NN).
□
Align the two key slots in the top of the fan motor assembly
(C) with the two loosened screws (NN) on the mounting
plate (A). Push the fan motor assembly (C) up and turn it
clockwise to lock in the mounting plate (A). Tighten the two
screws.
□
Install the two screws that were removed at the beginning
of this step into the remaining two holes and tighten the
four screws firmly.
□
Install the trim ring (B) by aligning the ring's slots with the
screws on the mounting plate (A). Rotate the ring clockwise
to lock in place.
Assembly - Attaching the Fan Blade
1
Attaching the fan blades
NOTE: Blade installation must be properly completed before
attaching the light kit.
□
Attach a blade (D) to the fan motor assembly (C) by
inserting the blade (D) into slots in the side of the fan
motor assembly (C) and aligning the three screws holes in
the blade with the holes in the center flywheel and secure
with blade attachment screws (BB).
□
Make sure all the screws are firmly tightened.
□
Repeat these steps for the remaining blades.
A
D
9
Please contact 1-855-HD-HAMPTON for further assistance.
BB
HAMPTONBAY.COM
NN
B
C
C
Publicidad
