Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 33 Thursday, January 4, 2024 1:46 PM
OPERATION
Before Use
WARNING
• To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS before operating this appliance.
Operation Overview
1
Clean the Lint Filter
• If the lint filter has not already been
cleaned, lift out the filter and remove the
lint from the last load. This will help ensure
the fastest and most efficient drying
performance. Make sure to reinstall the
filter, pressing down until it clicks firmly into
place.
2
Load the Dryer
• Make sure that clothing is pushed entirely
into the drum and away from the door seal
area. Clothing that gets stuck between the
door and seal may be damaged or damage
the seal.
• If the load is extra large, you may need to
divide it into smaller loads for proper
performance and fabric care.
• All strings and attached belts of clothes
should be well tied and secured before
being put into the drum.
3
Turn on the Dryer
• Press the Power button to turn on the
dryer. The display will turn on and a chime
will sound.
4
Select a Cycle
• Turn the cycle selector knob until the
desired cycle is selected. The preset
temperature, dry level, and option settings
for that cycle will be shown.
5
Adjust Settings
Default settings for the selected cycle can now
be changed, if desired, using the cycle
modifier and setting buttons.
• Not all modifiers and options are available
on all cycles.
6
Begin Cycle
• Press the Start/Pause button to begin the
cycle. The cycle can be paused at any time
either by opening the door or by pressing
the Start/Pause button.
• If the Start/Pause button is not pressed
within a certain time, the dryer shuts off
and all settings are lost.
7
End of Cycle
• When the cycle is finished, the chime will
sound. Immediately remove your clothing
from the dryer to reduce wrinkling. If
Wrinkle Care is selected, the dryer will
tumble briefly every few minutes to help
prevent wrinkles from setting in the clothes.
Check the Lint Filter Before Every
Load
Always make sure the lint filter
starting a new load; a clogged lint filter will
increase drying time. To clean, pull the lint filter
straight up and roll any lint off the filter with your
fingers. Push the lint filter firmly back into place.
See Regular Cleaning for more information.
Always ensure that the lint filter is properly
installed before running the dryer. Running the
OPERATION
33
is clean before
a
Publicidad
