Rothenberger Universal ROTIGER VARIO Electronic 5.0301 Instrucciones De Uso página 15

8. Use of this tool can generate and disburse
dust or other airborne particles, including
wood dust, crystalline silica dust and
asbestos dust. Direct particles away from
face and body. Always operate tool in well
ventilated area and provide for proper dust
removal.Use dust collection system wherever
possible. Exposure to the dust may cause
serious and permanent respiratory or other
injury, including silicosis (a serious lung
disease), cancer, and death. Avoid breathing
the dust, and avoid prolonged contact with
dust. Allowing dust to get into your mouth or
eyes, or lay on your skin may promote
absorption of harmful material. Always use
properly fitting NIOSH/OSHA approved
respiratory protection appropriate for the dust
exposure, and wash exposed areas with
soap and water.
Terminology:
DANGER: indicates an imminently hazardous
situation which, if not avoided, will result in
death or serious injury.
WARNING: indicates a potentially hazardous
situation which, if not avoided, could result in
death or serious injury.
CAUTION: indicates a potentially hazardous
situation which, if not Avoided, may result in
minor or moderate injury. or indicates
potentially hazardous situation which, if not
avoided, may result in property damage.
NOTE: indicates useful advice for operating
the machine for best performance or
convenience, etc.
MOTOR
Always check the nameplate to ensure the A.C.
current supply is the correct voltage for your
machine.
This tool will operate on voltage within plus or
minus 5 percent of that shown on the
specification plate on the tool. Refer to the
specification plate on your tool for proper voltage
and current rating.
Do not operate your tool on a current on which
the voltage is not within correct limits.
If an extension cord is used, make sure the
conductor size is large enough to prevent
excessive voltage drop which will cause loss of
power and possible motor damage.
If an extension cord is to be used outdoors, it
must be marked with the suffix WA or W following
the cord type designation. For example – SJTW-
A to indicate it is acceptable for outdoor use.
Always choose the shortest possible cord.
EXTENSION CORD SELECTION
Total Extension Cord
Length (feet)
25
50
100
150
200
RECIPROCATING SAW
* Storage case
* Blade
* Hex wrench
FOREWORD
This Reciprocating Saw is designed for cutting
metal up to 20mm (3/4") thick, wood up to
300mm (12") thick (depending on the blade), and
various other materials, such as plastics,
fiberglass, hard rubber, etc.
SELECTING THE BLADE
For best performance, longer blade life, and
smoother cut, selects the proper blade for the
job.
When cutting metal always select a blade which
will allow at least three teeth to be engaged in the
thickness of material.
WARNING: NEVER TOUCH BLADE
IMMEDIATELY AFTER USE, AS IT MAY BE
HOT ENOUGH TO CAUSE SEVERE BURNS.
TO PREVENT ACCIDENTAL ELECTRICAL
SHOCK THE SAW MUST BE HELD WITH ONE
HAND ON THE MAIN HANDLE AND THE
OTHER HAND ON THE RUBBER GEARCASE
COVER. THE RUBBER GEARCASE COVER
MUST BE FREE OF DAMAGE AND
PROPERLY INSTALLED AT ALL TIMES.
MOUNTING THE BLADE
WARNING: Make sure to unplug the power
cord when mounting or removing the blade.
Warning: Be absolutely sure to hold the flat
top of the blade, instead of the teeth, to
prevent any accident.
ENGLISH
Cord Size (AWG)
16
12
10
8
6
14