Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting the battery
1.
Push the battery (4) into the battery mount of the compatible power tool. The battery (4) clicks in-
to place audibly.
Removing the battery
1.
Press the battery (4) release button (6) and pull the battery (4) out of the battery mount of the
compatible power tool.
8.3
Check the charge status of the battery
The charge status indicator (5) indicates the charge status of the battery (4).
The charge status of the battery is indicated by the corresponding LED light lighting up.
1.
Press the charge status indicator button (7) on the battery (4).
LED on the battery
red-orange-green
red-orange
red
8.4
Depleted batteries
• A significantly shortened operating time despite charging indicates that the battery has been
used up and needs to be replaced. Only use original replacement batteries.
• In any case, observe the applicable safety instructions as well as regulations and instructions on
environmental protection (see "Disposal and recycling").
9
Electrical connection
The connection complies with the applicable VDE and DIN provisions. The customer's mains
connection as well as the extension cable used must also comply with these regulations.
9.1
Important information
If the battery overheats, the charging process is terminated and the battery charger is switched off.
After the battery has cooled down, the charging process can be resumed.
Connection type Y
If it is necessary to replace the mains connection cable, this must be done by the manufacturer or
their representative to avoid safety hazards.
10 Cleaning
WARNING
Unplug the plug from the socket before carrying out any work on the battery charger.
• Clean the product with a dry cloth or brush.
• Do not use water or metallic objects.
11 Maintenance
The product is maintenance-free.
22 | GB
Charging status
Battery full
Battery partially charged
Battery empty
www.scheppach.com
Publicidad
