GreenWorks 24252 Manual Del Operador página 7

10.2 INSTALL THE TUBE
1. Move the tube (6) until the lock button engages into the
slot.
2. Connect the nozzle to the tube until the latch on the tube
engages into the opening on the nozzle.
6
4
You can use the nozzle to increase airflow in tight areas.
10.3 INSTALL THE BATTERY PACK
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
10.4 REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
English
TIP
11 OPERATION
WARNING
Make sure the blower tube is in position before operation.
11.1 START THE MACHINE
1. Push the on/off button (2) in the on position.
2. Turn the speed dial (1) forward to increase speed.
5
4
11.2 STOP THE MACHINE
1. Push the on/off button in the off position.
11.3 SPEED NOZZLES
The machine has a two speed high velocity nozzle tip (4)
which sets the machine at highest speed.
1. Move the speed nozzle tip up to high speed.
2. Move the speed nozzle tip down to low speed.
5
4
11.4 OPERATION TIPS
• Blow around the outer edge of the unwanted materials to
prevent the unwanted materials from scattering.
• Use rakes and brooms to clear the unwanted material
before you blow.
• Make the surfaces wet before you clear the unwanted
material in dusty conditions.
• Look out for children, pets, open windows, and cleaned
cars during operation.
• Clean the machine.
• Discard the unwanted material when you complete work.
7
1
2
3
6
1
2
3
6
EN