Publicidad
Idiomas disponibles
Idiomas disponibles
1600A01UV3.qxp_GKS18-25 4/27/20 8:12 AM Page 20
Precision Sawing With Track
used to change the depth while the saw is
in operation, or for plunge cutting. If
blade adjustment shifts while cutting, it
may cause binding and kickback.
The GKS18V-25GC can be used with the
Bosch track system to enhance the
straightness of the cut (Fig. 15b).
•
Make sure that track 40 is prepared,
positioned and clamped as shown in
"Preparing Track" section on page 22.
•
Make sure that the saw's footplate is
properly placed on track. This is
achieved when the 28a slot on the
bottom of the saw is placed over the
raised ridge in the Bosch tracks (Fig.
15a). (The 28b slot will fit over some
tracks from other manufacturers, but
we recommend that this saw be used
only with Bosch saw tracks.)
•
Take extra care when placing saw on
portion of a track that extends beyond
Fig. 15a
20
ind Quality Products Online at:
Operating Instructions
The depth adjustment
system should be not
50
40
GlobalTestSupply
www.
Fig. 15a
the leading or ending edge of the
workpiece.
•
Prior to removing saw from track,
raise saw head and retract blade first
and allow blade to come to a
complete stop.
40
28b
28a
.com
sales@GlobalTestSupply.com
40
Publicidad
