References; Maintenance; More Information - Kenwood KDC-X302 Manual De Instrucciones

TROUBLESHOOTING
Symptom Remedy
Voice calling method is • Use voice calling method in a more quiet environment.
not successful. • Reduce the distance from the microphone when you speak the
name.
• Make sure the same voice as the registered voice tag is used.
Sound is being • Reduce the distance between the unit and the Bluetooth audio
interrupted or skipped player.
during playback of a • Turn off, then turn on the unit and try to connect again.
Bluetooth audio player. • Other Bluetooth devices might be trying to connect to the unit.
• Check whether the connected Bluetooth audio player supports
The connected Bluetooth
audio player cannot be Audio/Video Remote Control Profile (AVRCP). (Refer to the
controlled. instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"DEVICE FULL" The number of registered devices has reached its limit. Retry after
deleting an unnecessary device. ( 21, DEVICE DELETE)
"N/A VOICE TAG" Make sure the same voice as the registered voice tag is used.
"NOT SUPPORT" The connected phone does not support Voice Recognition feature or
phonebook transfer.
"NO ENTRY"/"NO PAIR" There is no registered device connected/found via Bluetooth.
"ERROR" Try the operation again. If "ERROR" appears again, check if the
device supports the function you have tried.
"NO INFO"/"NO DATA" Bluetooth device cannot get the contact information.
"HF ERROR XX"/ Reset the unit and try the operation again. If this does not solve the
"BT ERROR" problem, consult your nearest service center.
"SWITCHING NG" The connected phones might not support phone switching feature.
32
ENGLISH

REFERENCES

Maintenance

Cleaning the unit
Wipe off dirt on the faceplate with a dry silicone or soft cloth.
Cleaning the connector
Detach the faceplate and clean the
connector gently with a cotton swab, being
careful not to damage the connector.
Handling discs
• Do not touch the recording surface of the disc.
• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
• Do not use any accessories for the disc.
• Clean from the center of the disc and move outward.
• Clean the disc with a dry silicone or soft cloth. Do not use any solvents.
• When removing discs from this unit, pull them out horizontally.
• Remove burrs from the center hole and disc edge before inserting a disc.

More information

For: – Latest firmware updates and latest compatible item list
– KENWOOD original application
– Any other latest information
Visit <www.kenwood.com/cs/ce/>.
General
• This unit can only play the following CDs:
• For detailed information and notes about the playable audio files, visit
<www.kenwood.com/cs/ce/audiofile/>.
Connector (on the reverse
side of the faceplate)