Kenwood KDC-X302 Manual De Instrucciones página 40

INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
Orientate the trim plate
as illustrated before
fitting.
When installing without the mounting
sleeve
1 Remove the mounting sleeve and trim plate from
the unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
screws (supplied/commercially available).
Use only the specified screws. Using wrong screws
might damage the unit.
36
ENGLISH
Do the required wiring.
( 37)
Hook on the top side
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into the holes
on both sides of the trim plate, then pull it out.
3 Insert the extraction keys deeply into the slots on
each side, then follow the arrows as shown on the
illustration.
Part list for installation
(A) Faceplate
(B) Trim plate
Dashboard of
your car
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
(F) Screws (supplied for
/
)