EGAmaster ROSCAMATIC-3 COMBI Manual De Instrucciones página 10

B) LOOSE THE PIPE
B- A sharp jerk will release the pipe.
B
C) PREPARATION FOR THREADING
C1- Select the correct die head and dies as required.
C2- Insert the set of dies in the die head as numbered and make the die thread coincide with the
positioning ball of the die head, until a "klick" sounds.
C3- Once the dies are positioned, turn the lever nut to lock until you get the desired measure.
C4- Set the thread length desired by means of the dial.
C1
D) THREADING
D1- Raise cutter and reamer out of the way.
D2- Lower the die head to the carriage in such a way that the extremity of die head body is locked
by the carriage buttom.
D3- Set the speed change lever for the size indicated.
D4- Switch on the machine. Use an oiler to lubricate the threading.
D5- Advance the carriage until the dies engage the pipe pressing it to start the threading and kee-
ping it until 2 threads are produced, releasing after because the thread itself would drive the
carriage during the rest of the threading.
D6- The die head will automatically open the dies when the threading length is the selected by the
dial threading length.
D7- Stop the machine.
D8- Retract carriage to the initial position.
10
B
C2 C3 C4