EGAmaster ROSCAMATIC-3 COMBI Manual De Instrucciones página 11

D1
D5
CUTTING AND REAMING
E) CUTTING
E1- Raise reamer and die head out of the pipe.
E2- Lower the cutter to work position and by turning cutter handle open up cutter guide wider than
the width of the pipe.
Move carriage to position where pipe is to be cut.
E3- Cut the pipe turning the cutter handle in each turn of the pipe until cut is completed.
NOTE: take care that the pressure made by the cutting blade isn't excessive. Due to pipe defects it
can cause pipe deformity or bursts in the cutting blade.
E1
D2
D6
E2
D3
D7
E3
D4
COD. 64002/06
COD. 64130
D8
11