Hoover CLEANSLATE Manual Del Usuario página 4

FORMULA RATIO CHART
IF USING HOOVER CONCENTRATE
Tank Size 40 oz
Formula
TROUBLESHOOTING
Replacement parts and accessories such as solutions available at Hoover.com.
If an appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call customer service at 1-800-944-9200 prior to continuing use.
Always identify your cleaner by the complete model number. (The model number appears on the bottom of the cleaner.)
PROBLEM
Cleaner won't run
Cleaner won't pick up or low suction
Water escaping from Cleaner
Cleaner won't dispense
Hose nozzle will not spray after filling the
Clean Water Tank or Solution Tank Container.
Motor noise becomes high-pitched
SMALL AREA (20 OZ)
Tough Stains: Use formula at 100% concentration.
Fill formula Small Area Line (20 oz)
POSSIBLE CAUSE
1. Power cord not firmly plugged into outlet.
2. Blown fuse or tripped breaker.
3. Needs service.
1. Recovery Tank is not installed correctly.
2. Recovery Tank is full.
3. Recovery Tank is clogged.
4. Air path is clogged.
5. Recovery Tank debris filter is clogged.
1. Recovery Tank is full.
2. Recovery Tank is not installed correctly.
3. Solution Tank not installed properly.
1. Solution Tank is empty.
2. Solution Tank not installed properly.
3. Needs service.
1. Air is trapped in the pump and hose.
1. Recovery Tank is full.
2. Recovery Tank is clogged.
3. Air path is clogged.
4. The float in the Recovery Tank has been activated.
WARNING:
To reduce the risk of personal injury - Unplug before cleaning or servicing.
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace fuse/reset breaker in home.
3. Visit our website at www.hoover.com or call 1-800-944-9200.
1. Check placement of Recovery Tank in base of cleaner.
2. Empty Recovery Tank.
3. Clean Recovery Tank.
4. Remove Hose and Flush out with Clean Water.
5. Remove debris filter and rinse thoroughly, then replace.
1. Empty Recovery Tank.
2. Check placement of Recovery Tank in base of cleaner.
3. Review "Getting Started" for Solution Tank Installation.
1. Fill Solution Tank.
2. Review "Getting Started" Solution Tank Installation.
3. Visit our website at www.hoover.com or call 1-800-944-9200.
1. Turn on the cleaner. If the hose does not spray, prime the pump by lowering
1. Empty Recovery Tank.
2. Clean the Recovery Tank.
3. Unclog air path.
4. Review Cleaning the Recovery Tank.
LARGE AREA (40 OZ)
General Cleaning: Use 5 oz of formula to 35 oz water.
Fill water and formula to Large Area Line (39 oz)
the hose down to the floor and hold the trigger for up to 1 minute.