Publicidad
Idiomas disponibles
Idiomas disponibles
F E AT U R E S - O P E R AT I O N S
TECHNICAL SPECIFICATIONS
• Amps: 12.5
• Wattage: 1500W (+5% –10%)
• Working voltage: 120V AC/60Hz
WALL MOUNT INSTALLATION
INSTRUCTIONS
Your heater comes fully assembled and ready for
immediate use. It also comes with a Wall Mount Bracket
which allows you to mount the heater on wall.
Wall Mount Installation:
1. Carefully remove your heater and the Wall Mount
Bracket from the box.
2. Secure the mounting bracket to the wall as shown.
(See Figure 1)
Figure 1
Mounting Tab
3. Turn heater sideways and position the mounting tab
on the back of the heater so it lines up with the
mounting bracket .
4. Place mounting tab into the mounting bracket and
rotate heater into the upright position to lock it in place.
Please Note: Due to the multitude of potential mounting
surfaces, mounting screws are not included with this
product. Please visit your local hardware store to determine
which type of screw is best for your particular wall.
OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box, please
save the carton for off-season storage.
2. Place heater on firm level surface.
3. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500
Watts, this unit draws 12.5 Amps.
4. Plug the heater into a 120V AC electrical outlet.
1TOUCH
INSTRUCTIONS
Your heater is equipped with a technologically advanced
1Touch
heater to run continuously in manual mode or set the
thermostat to your desired temperature setting. The
thermostat will automatically turn the heater ON or OFF
depending on the preset comfort level. The comfort level
ranges between 60° and 80° Fahrenheit. Pressing the
Mode/Off Button to select your desired comfort level:
Mounting
1. HI - Manual HIGH
Bracket
Press the Mode/Off Button once to set the heater at HI
manual setting. The HI Indicator Light will illuminate. The
heater will run continuously at HIGH setting.
2. LO - Manual LOW
Press the Mode/Off Button again to set the heater at LO
manual setting. The LO Indicator Light will illuminate. The
Mounting Screws
(not included)
Figure 2
A. LOW Heat Indicator
B. MODE/OFF BUTTON
C. HIGH Heat Indicator
HEATER'S THERMOSTAT
®
heater's electronic thermostat. You can set the
®
D
A
B
D. SET TEMPERATURE
C
Indicator
Publicidad
