Publicidad
Idiomas disponibles
Idiomas disponibles
C L E A N I N G / M A I N T E N A N C E
heater will run continuously at reduced wattage.
NOTE: To shut unit off at any time, press and hold the
Mode/Off Button for 2 seconds or keep pressing the
Mode/Off Button until all temperature indicators go OFF.
3. Preset Temperature Levels (60 °F - 80 °F)
Continue to press the Mode/Off Button to cycle through the
Temperature Indicators (60 °F - 80 °F) until your desired
temperature is set in either HI or LO setting. The selected
Temperature Indicator Light will illuminate. When the ambient
temperature rises above the set temperature, the heater will
stop. When the ambient temperature drops below the set
temperature, the heater will turn on automatically.
NOTE: There will be temperature variance measured at
the internal sensor, when the ambient temperature drops
below the set temperature, it may take a longer time for
the internal sensor to cool down, and then re-activate the
heater to turn on again. If the ambient temperature is
too low, either raise the set temperature level or select
HI/LO setting for constant heat.
NOTE: When the 1Touch
®
either the HIGH Heat (HI) or LOW Heat (LO) indicator,
and the SET TEMPERATURE indicator will remain lit during
operation. (See Figure 2)
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the set temperature. To prevent the unit from
cycling, you need to raise the thermostat setting.
NOTE: 1Touch
heater has memory. The thermostat will
®
remember the previous temperature setting after the unit
has been turned off. However, if the unit is unplugged, the
thermostat will be reset and will no longer remember the
previous temperature setting.
heater's thermostat is set,
CLEANING/MAINTENANCE
During Season Care:
1. Always unplug the heater before cleaning.
2. Clean the unit with a soft cloth moistened with a mild
soap and water solution.
3. NEVER use abrasive or flammable solvents to clean
the unit.
4. After cleaning, be sure to completely dry the unit
with a cloth or towel.
After Season Care:
1. Store heater in a cool, dry location.
2. It is recommended that you store the unit in its
original carton.
AUTO SAFETY SHUT-OFF
This heater is equipped with a patented, technologically
advanced, safety system that requires the user to reset
the heater if there is a potential overheat situation. When
a potential overheat temperature is reached, the system
will automatically shut the heater off. It can only resume
operation when the user resets the unit.
RESET INSTRUCTIONS
If your heater shuts down:
1) Unplug the unit and wait 30 minutes.
2) Plug in and operate normally.
Publicidad
