Kerbl cit EcoKill LED Instrucciones De Uso página 7

3. Operating instructions
3.1. Function
By means of ultraviolet light, flying insects are lured into the effective range of the device. Attached in front of the light tube is a
screen charged with high voltage. Upon contact with this high-tension screen the insects are quickly and hygienically killed. The
fallen insects are collected in a drip pan which only has to be removed from the housing for emptying.
3.2. Unpacking
Open the packing carefully and remove all the parts. Avoid scratching the device on sharp or pointed objects. Make sure that none
of the parts, in particular the chain and the drip pan, is left in the packing. Keep the operating instructions in a safe place!
3.3. Assembly/erection
The device can be
- put in place or
- suspended on the chain which is included.
Relevant for both variants: Make sure the device is not placed too close to sources of ignition, i.e. easily combustible objects.
The device is not made for outdoor use!
3.3.1. The device is put in place
Make sure that the underground is even and dry and that no easily ignitable objects are in the immediate vicinity of the device. The
site of installation should likewise be beyond the reach of children. For smooth functioning it is important that the device is
set up so that insects can fly unimpeded toward the light from both sides. Other sources of light and drafts have a
negative affect on the effectiveness of the UV light.
3.3.2. The device is suspended
Choose the site with care. Other sources of light and drafts have a negative affect on the effectiveness of the UV light. Make sure
that the chains are firmly attached to the device. Install the insect killer between 1.5 und 3.0 m above the ground.
Caution: Do not hang outdoors! The device is for indoor use only!
3.4. Servicing/Cleaning
Switch the device off and pull the power plug before cleaning. Empty the drip tray regularly - at least once a week. When
doing this, pull it carefully out of the housing. The pan can then be rinsed with water. Let it dry before reinserting. The protective
screen, the high-voltage screen and the UV lamps can be cleaned with a dry cloth or with a brush.
4. Specifications
Mains voltage: 220 - 240 Volt
Frequency: 50 Hz
Power: 14 Watt
High voltage: 2.200 Volt
Effective range: max. 150 m2
Declaration of conformity
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamental requirements and other relevant
stipulations and regulations. The CE-/UKCA-mark confirms compliance with the Directives of the European Union or the relevant UK legislation. The declaration of
conformity can be viewed by visiting www.kerbl.com
Electrical waste
It is up to the operator to dispose of the device responsibly after its useful life in accordance with local regulations. Consult the relevant regulations for your
country. The device must not be disposed of in household waste. Under the terms of the EU Directive on the disposal of old electrical and electronic equipment,
the device can be taken to local authority-run refuse sites or recycling plants free of charge, or returned to dealers who offer a returns service. Correct disposal
protects the environment and prevents any possible harmful impacts on humans and the environment.
7