YATO YT-82772 Manual Original página 11

PRODUCT CHARACTERISTICS
A drill driver is a universal portable device that does not need any external source of power supply, intended for handymen for
making holes in various materials (e.g. wood and wood-related materials, metals), for screwing and unscrewing various screws
and bolts, and also for impact drilling in hard ceramic materials (e.g. concrete). Its particular advantages will be appreciated by
handymen performing various assembly and fi nishing works. This product is not designed for commercial applications. Correct,
reliable and safe operation of this power tool depends on proper operation, therefore:
Before starting the work with this tool, please read this manual and keep it properly.
The supplier does not assume any liability for damages resulting from failure to follow safety regulations and recommendations
specifi ed in this manual.
EQUIPMENT
The device is delivered complete and does not require assembly.
Attention! The product has not been equipped with a rechargeable battery and charging station.
TECHNICAL PARAMETERS
Parameter
Catalogue number
Operating voltage
Rotation (idle running)
Impact frequency
Max. torque
Noise level
- acoustic pressure L ± K
pA pA
- acoustic power L ± K
wA wA
Protection class
Insulation class
Oscillation level a ± K
h
Weight
Tool chuck
Maximum drilling diameter
- in wood
- in concrete
- in steel
Battery type
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters what-
soever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
O R I G I N A L
EN
Measuring unit
[V]
[min ]
-1
[min -1 ]
[Nm]
[dB]
[dB]
[m/s ]
2
[kg]
[mm]
[mm]
[mm]
I N S T R U C T I O N S
Value
YT-82772
18 DC
0 - 1000
0 - 5000
2,4
89,0 ± 3,0 / 89,0 ± 3,0
100,0 ± 3,0 / 100,0 ± 3,0
IPX0
III
13,286 ± 1,5 / 9,473 ± 1,5
2,3
SDS+
30
24
13
YATO 18 V Li-Ion
11