Publicidad
Idiomas disponibles
Idiomas disponibles
3. System Installation and Typical Applications
3.1 System Installation
Keboard Installation
Before you start connecting the keyboard equipment to your system, make sure the units to be controlled are comple-
tely installed and everything is working correctly. Before use of this keyboard, you should set the protocol and baud
rate (.4~57.6kbps) in the PTZ SETUP mode. Use the following steps to set the communication protocol and baud
rate.
3.2 PTZ Setup
PTZ Setup mode, select +
Setup screen allows you to make change each programmable clause.
NOTE: The baud rate must be the same between the controlled unit and the keyboard.
PTZ Setup
[PTZ SETUP
]
PASSWORD [****]
[PTZ SETUP
]
. ADDRESS: 00
[PTZ SETUP
]
. MODEL: WDS
[PTZ SETUP
]
3. PROTOCOL: PEL-D
[PTZ SETUP
]
4. BAUDRATE: .4K
[PTZ SETUP
]
5. PARITY: NONE
[PTZ SETUP
]
6. PROP: ON
[PTZ SETUP
]
7. SAVE
[PTZ SETUP
]
8. EXIT
, (~3 seconds)
: PASSWORD INPUT [4 DIGITS] – Factory Default: 0000
: ADDRESS CHANGE [~55] +
: MODEL CHANGE [WDS / WCY / PEL ... ETC]
: PROTOCOL CHANGE [PEL-D / PEL-P / WON-D, ... ETC]
: BAUDRATE CHANGE [.4KBPS ~ 5736KBPS]
: PARITY CHANGE [NONE / EVEN / ODD]
: PROP (ON/OFF): Proportional Speed Control
: SETUP DATA SAVE
: MENU EXIT
8
: SETUP MENU STAGE MOVE
: COMMAND EXECUTION
Publicidad
