General Characteristics - Cembre RH-FL75 Manual De Uso Y Mantenimiento

HYDRAULIC PULLER TYPE PUNCHING HEAD
• Before each use, check the punches, dies and draw studs, and replace any that are worn or
damaged, particulary any punches that have damaged cutting surfaces.
• Damaged or improperly assembled accessories can break and hit the operator with suffi cient
force to cause serious injuries.
• Before each use, verify the integrity of the head; replace any worn, possibly damaged or
missing parts with original Cembre spares.
• Only for use in punching holes in single layers of material and thicknesses as shown in tables
on pages 19 and 20. Any other use may cause components to break with potential risk of serious
injury.
• During operation do not allow anyone to pause in the work area, especially in front of the
punch.
• The use of Cembre punching accessories is recommended. Accessories from other suppliers
may not be designed to withstand the force generated by this tool and may be damaged or
break with potential risk of serious injury.

1. GENERAL CHARACTERISTICS

– Application range: suitable for punching single layers of stainless steel, mild steel, fi breglass and
plastic material.
– Max. puncing capacity: ........................................................................................... ø 140 mm
– Developed force: ....................................................................................................... 75 kN
– Max. operating pressure: ....................................................................................... 700 bar
– Oil necessary (displacement): ............................................................................... 25 cm
– Dimensions: length ................................................................................................... 163 mm
width .................................................................................................... 106 mm
– Weight: ........................................................................................................................... 1,9 kg
The part code "RH-FL75" includes the following:
– Hydraulic head.
– ø 11.5 mm Spiral bit (code 6134070).
– TD-11 Draw stud with threaded 7/16"-3/4" (code 2685005).
– TD-19 Draw stud with threaded 3/4"-3/4" (code 2685008).
– Plastic carrying case type VAL-P29.
2. INSTRUCTIONS FOR USE
The head is supplied with an automatic, quick fi t male coupler suitable for connection to a hydraulic,
pneumatic or electrical 700 bar pump from the Cembre range.
3
TYPE RH-FL75
CAUTION
ENGLISH
(5.5 in.)
(8.4 sh.ton.)
(10,000 psi)
3
(1.52 cu. in)
(6.41 in.)
(4.17 in.)
(4.18 lbs)