Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
If burner does not light or flame is too low, you may
have spider or other insect blockage
in burner, or the
flow limiting device has been activated.
See "Burner
Assembly/Maintenance"
under Proper Care and
Maintenance,
or "Regulator
Resetting
Procedure"
under Connecting
LP Cylinder and Hose/Regulator
to Grill.
Note:
If burner does not light or flame is too low, you may
have spider or other insect blockage
in burner, or the
flow limiting
device has been activated.
See "Burner
Assembly/Maintenance"
under Proper Care and
Maintenance,
or "Regulator
Resetting
Procedure"
under Connecting
LP Cylinder and Hose/Regulator
to Grill.
LIGHTING THE MAIN BURNERS:
1.
Open lid before lighting burner.
2.
Make sure all control knobs are in the "OFF" position.
3.
Push and hold down the IGNITION BURNER
control knob and
turn to _"Hi".
Press and hold the ELECTRONIC
IGNITION
BUTTON for 3-5 seconds
to light burner.
4.
If ignition does NOT occur in 5 seconds,
turn control
knob to
"OFF", wait 5 minutes to allow gas to clear away and repeat
lighting
procedure.
5.
To light other burners, turn control knob to "Hi" in sequence
from right to left.
6.
To turn off, turn each control knob clockwise
until it locks in the
"OFF" position. This does not turn off the gas flow from the
cylinder.
MATCH LIGHTING THE MAIN BURNERS:
1.
2.
3.
Open lid before lighting.
Turn the burner control
knobs to "OFF".
Place a paper match in the end of the matchlighter.
Strike the
match and place through
lighting hole in the left hand side of
the grill to approximately
1/2" (1 to 2 cm) from the burner.
4.
Turn on the FAR LEFT burner control
knob to the "HI" position.
The burner should light within 5 seconds.
5.
If the burner does not light, turn the control knob to "OFF" and
wait 5 minutes for gas to clear away and repeat lighting
procedure.
6.
To light other burners, push and turn control knobs to "Hi" in
sequence
from left to right. Follow Step 5.
7.
If the burner does not light within the first few attempts
of
match lighting, there is a problem
with the gas supply. Turn off
the gas at the burner and cylinder. DO NOT attempt
to operate
the grill until the problem
is found and corrected.
See
"Troubleshooting"
section of this manual.
LIGHTING THE SIDE BURNER:
1.
Open lid before lighting side burner.
2.
Push and turn side burner control knob to _¢"Hi". Press and
hold the ELECTRONIC
IGNITION BUTTON for 3-5 seconds
to
light burner.
3.
If ignition does NOT occur in 5 seconds,
turn control knob to
"OFF", wait 5 minutes to allow gas to clear away and repeat
lighting procedure.
4.
To turn off, turn control knob clockwise
until it locks in the
"OFF" position.
MATCH LIGHTING THE SIDE BURNER:
1.
2.
3.
4.
5.
6.
Open the lid to the burner before lighting.
Turn the burner control knob to "OFF".
Strike and carefully place a match approximately
1/2"
(1 to 2 cm) from the burner.
Turn the burner control knob to the "Hi" position.
If ignition does NOT occur in 5 seconds,
turn control knob to
"OFF", wait 5 minutes to allow gas to clear away and repeat
lighting procedure.
If the burner does not light within the first few attempts
of
match lighting, there is a problem
with the gas supply. Turn off
the gas at the burner and cylinder.
DO NOT attempt
to operate
the grill until the problem
is found and corrected.
See
"Troubleshooting"
section of this manual.
Note:
Observe
flame height when lit: Flame should
be a Blue/Yellow
color between
1 "-2" when
burner is on "Hi".
TURNING OFF THE GRILL:
1.
Turn off the cylinder
valve.
2.
Turn all burner knobs to OFE
Note:
Turn off LP cylinder first to prevent gas from being
left in the system
under pressure.
CAUTION:
The cylinder valve should always be in the off, or
closed, position
when the grill is not in use.
To turn offthe
cylinder valve,
turn knob clockwise
until it stops.
t5
Publicidad
