ISE SY-7020 Manual De Instalación E Instrucciones página 24

EN
Step 5:
1. According to the figure, first place the (7) handlebar holder on the (6) handle adjustment
bracket, and thentake the (17) M18X16, cylindrical hexagonal screws, (15) ø8.5mm flat
gasket Tighten the handle adjustment bracket (6) and handle holder (7) with an Allen key
(23). Finally install (25).
2. Adjust the handle frame up and down; according to the illustration, first turn the adjust-
ment knob (11) to the appropriate position, and then pull the adjustment knob outward to
make the handle adjustment frame (6) move up and down smoothly and adjust to the appro-
priate position (11) Tighten the adjustment knob to adjust the handlebar.
8