Publicidad
Idiomas disponibles
Idiomas disponibles
1) Prepare parts to install.
Faceplate
2)
Wrap pipe tape around threads of
adapter.
Install the adapter using 12mm hex
wrench, and if needed, an adjustable
wrench (for leverage).
Tighten until the screw holes in the
adapter are in the positions shown in
the image.
3)
Cut off part of the outer plaster guard that protrudes
from the wall surface with a hacksaw, and make sure
the edge of the outer plaster guard is ush with the
nished wall surface after cutting.
ATTENTION:
When cutting the outer plaster guard, make sure the
edge is cut off neatly. (The edge should not be
recessed in the nished wall surface)
4)
Confirm the distance from the front of the
adapter to the finished wall surface.
The distance shall be 0 to 13/16" (20mm). If
the distance is not within this range, adjust
the supply line or adapter to the correct
position.
Installing the Body Spray (TBW08008U)
Adapter
Set Screw
Screws
Screw Hole
Min 0"(0mm)
Max 13/16"(20mm)
Finished Wall
Surface
4
Outer Plaster
Guard
Body Spray
Assembly
Adapter/Outer
Plaster Guard
12mm
Hex Wrench
Publicidad
