Kenmore 106.4673 Serie Manual De Uso Y Cuidado página 14

Installing theStatus Indicator
The produce preserver comes with a status indicator, which should
be activated and installed at the same time the pouches are
installed.
• When both doors are closed, the hinged seal automatically
forms a seal between the two doors.
A
1. Place the indicator face-down on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator until
the bubble pops, to activate the indicator.
3. Slide open the cap on the top of the produce preserver housing.
4. Place the indicator in the top of the housing, facing outward.
5. Slide the cap closed, and check that the indicator is visible
through the rectangular hole in the cap.
NOTE: The cap will not easily close if the indicator's bubble has
not been popped.
Replacing the Produce Preserver
The disposable pouches should be replaced every 6 months, when
the status indicator has completely changed from white to red.
To order replacements, contact us.
1. Remove the used pouches from the produce preserver housing.
2. Remove the used status indicator.
3. Install the replacement pouches and status indicator using the
instructions in the previous sections.
Replacement Parts:
To order stainless steel cleaner or replacement filters, in the U.S.A.
call 1-844-553-6667, and in Canada call 1-800-469-4663. Ask for
the appropriate part number listed below or contact your
authorized Kenmore dealer.
Stainless Steel Cleaner and Polish:
Order Part #D22 M40083 R
REFRIGERATOR USE
There are two refrigerator compartment doors. The doors can be
opened and closed either separately or together.
There is a vertically-hinged seal on the left refrigerator door.
• When the left-hand refrigerator door is opened, the hinged
seal automatically folds inward so that it is out of the way.
A.H/nged seal
IMPORTANT:
• Wait 24 hours for your refrigerator to cool completely before
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool the
compartments any faster.
• The recommended setting should be correct for normal
household refrigerator use. The controls are set correctly when
milk or juice is as cold as you like and when ice cream is firm.
• If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not blocked
before adjusting the controls.
Control Panel
Your refrigerator has an internal control panel, located at the top of
the refrigerator compartment.
l Replace Filter Cooling [_ "_l
off
Freezer Temp Air Filter Fast Cool Moisture Control Lock Fridge Temp
Temperature Control
For your convenience, the temperature control is preset at the
factory. When you first install your refrigerator, make sure the
control is still set to the recommended setting as shown.
14