Descargar Imprimir esta página

Kenmore 106.4673 Serie Manual De Uso Y Cuidado página 17

Refrigerador con congelador en la parte inferior

Publicidad

Idiomas disponibles

Idiomas disponibles

Crisper Drawers
To remove
and replace
the crisper drawer:
1.
Slide the crisper
drawer
straight
out to the stop. Lift the front
and slide the drawer
out the rest of the way.
2.
Replace
the drawer
by sliding the drawer
in fully
past the stop.
DOOR FEATURES
NOTE: Your model
may have some or all of these features.
To remove
and replace
the condiment
bins:
1.
Tilt the bin by pulling
it outward.
2.
Remove the bin by lifting
it upward
off the glides.
3.
Replace
the bin by sliding it back onto the glides and then push
it closed.
Crisper Cover
To remove
and replace
the glass crisper cover:
1.
Pull the glass straight
out.
2.
Replace
the glass by pushing
it straight
in.
Crisper Humidify Control
(on some models)
You can control
the amount
of humidity
in the moisture-sealed
crisper. Adjust
the control
to any setting
between
LOW and HIGH.
LOW
(open) lets moist air out of the crisper
for best storage
of
fruits and vegetables
with skins.
Fruit: Wash,
let dry and store in refrigerator
in plastic
bag or
crisper. Do not wash or hull berries
until they are ready
to use.
Sort and keep berries
in original
container
in crisper, or store in
a loosely closed
paper
bag on a refrigerator
shelf.
Vegetables
with skins: Place in plastic
bag or plastic
container
and store in crisper.
HIGH
(closed)
keeps moist air in the crisper for best storage
of
fresh, leafy vegetables.
Leafy vegetables:
Wash
in cold water, drain
and trim or tear
off bruised and discolored
areas. Place in plastic
bag or plastic
container
and store in crisper.
To remove
and replace
the fresh bin:
1.
2.
3.
Open
the bin by grasping
the top center
lip of the bin and
tilting
the bin outward.
Remove the bin by grasping
both sides of the bin and lifting
the
bin upward
off the glides.
Replace
the bin by sliding it back into its tilted
position
on the
glides and then push it closed.
1.
2.
3.
Ice Storage Bin
Wash
the ice storage
bin with mild soap and warm
water.
Slide the ice storage
bin under the ice maker, and push it
toward
the back as far as it will go.
Lower the arm on the ice maker to the ON
position.
NOTE:
It usually
takes approximately
24 hours for the ice
maker
to begin producing
ice. You may notice the ice has an
"off-taste."
If so, discard
the first three batches
of ice
produced.
After that the "off-taste"
should
be gone.
17

Publicidad

loading