us_main.book.book Page 17 Friday, February 7, 2020 11:44 AM
3
Connect all the wire harnesses
ground screw
.
e
NOTE
• The number of wire harnesses may vary
depending on the model.
• Ground wire is only available on some models.
Assembling the Left Refrigerator
Door
CAUTION
• Install the left refrigerator door after the right
door is installed.
1
Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator
door onto the middle hinge.
2
Fit the hinge
over the hinge lever latch
a
and slot it into place. Rotate the lever
clockwise and fasten the hinge.
3
and the
d
Connect all the wire harnesses and the
ground wire.
4
Push the water supply lines into the hole on
the top case and pull them through the
backplate.
5
Hold the water supply connection and gently
push in the collet
supply lines as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tubes in
place.
NOTE
• Disassembling/Assembling the Water Lines
b
c
Collet
e
INSTALLATION
to connect the water
d
Tube
Insert line
Clip
f
g
h
17