Product Overview:
The UV Water Treatment System has been engineered to rigid standards, and has been quality inspected at the factory prior to
packaging. Please review this manual in its entirety for a detailed system explanation, and ensure that the following components
accompany this system. To ensure system performance, all replacement components should be purchased directly from an autho-
rized dealer or online at www.ghpgroupinc.com. The use of components purchased from other sources will void the warranty, and
will potentially cause the system to function in a lesser capacity than intended.
A.
Item Description
A
System Assembly
B
Sediment Filter
C
Carbon Block Filter
D
UV Lamp
E
Quartz Sleeve
F
Owner's Manual
WARNING: Lamps must be replaced after 12 months of operation to ensure proper disinfection of your water.
Clean the Quartz Sleeve frequently for optimum performance.
A minimum 5 μ nominal pre-filter is recommended upstream (before) the UV system installation point. As UV system efficiencies
are dictated by penetration of the UV light through the water column, particulate matter within the water column could decrease
the disinfection capacity, and potentially create a harmful condition. A 5 micron sediment filter and 5 micron carbon filter is sup-
plied with the system.
Tools Required for Installation:
Safety
Adjustable
Goggles
Wrench
B.
C.
QTY
1
1
1
1
1
1
Pliers
Phillips
Screwdriver
D.
E.
Item Description
G
Anchor Bolts, 5/16" x 1.25"
H
Retaining Nut
I
VuCap
®
J
Flow Restrictor
K
5/16" Flat Washer
L
Quartz Sleeve Sealing O-Ring
M
Ground Wire Harness
Utility Knife
Measuring
Tape
F.
J.
G.
K.
H.
L.
I.
M.
QTY
2
1
1
1
2
1
1
Drill and 3/16"Bit
2