Troubleshooting
If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list.
Malfunctions:
The internal light does not illuminate.
The refrigerator do not cool well.
The food inside the refrigerator is
beginning to freeze.
The PURE WIND fan does not rotate.
The motor runs continuously.
The appliance makes a lot of noise.
The back wall of the refrigerator unit
is covered in frost or droplets of water
There is water at the bottom of the
refrigerator.
Possible causes / Solutions:
The plug has not been inserted into the electrical socket, or not far
enough to make contact, or there is no power in the house.
The TEMPERATURE CONTROL Knob is on OFF setting.
The door do not close properly or the seals are damaged.
The door are opened too frequently.
The TEMPERATURE ADJUSTMENT knob is not in the correct position
The refrigerator have been over-filled.
The TEMPERATURE ADJUSTMENT knob is not in the correct
position.
The food is in contact with the back inside wall of the refrigerator.
The PURE WIND system is only activated automatically when it
becomes necessary to restore perfect operational conditions inside
the refrigerator compartment.
The door is not closed properly or is continuously opened.
The outside ambient temperature is very high.
The appliance has not been installed on a level surface (see
Installation).
The appliance has been installed between cabinets that vibrate and
make noise.
The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.
This shows the appliance is operating normally.
The water discharge hole is blocked (see Maintenance).
GB
19