Oregon PS250 Manual De Instrucciones página 23

OPERATING THE POLE SAW
OREGON® Cord less Tool System
POLE SAW MODEL PS250
• Turn the extension collar counter
clock-wise (1) until the shaft slides
freely (Fig. 28).
• Slide the shaft until it is the desired
length (2).
•Turn the extension collar clockwise to
lock the shaft in place.
STOPPINGTHE POLE SAW
Release the trigger switch to stop the
pole saw.
STARTING THE POLE SAW
AWARNING:TO REDUCE THE RISK
OF INJURY, NEVER DEFEAT THE
INTERLOCK BY TAPING, WIRING, OR
TYING DOWN THE TRIGGER LOCK¬
OUT.
If using the harness, put on the harness
and attach the harness clip to the
attachment ring. Grasp the extendable
shaft and the rear handle firmly (Fig. 29).
Squeeze the trigger lock-out (1) with the
palm of the hand, and the trigger switch
(2) with the fingers.
CUTTING
(J)@®
QO@
BASIC CUTTING
A DANGER:TO REDUCETHE RISK OF
SHOCK, NEVER OPERATE THIS TOOL
NEAR ANY WIRES OR CABLES WHICH
MAY BE CARRYING ELECTRIC
CURRENT.
ELECTRICITY CAN ARC FROM ONE
POINTTO ANOTHER. MAINTAIN A
DISTANCE OF AT LEAST 50 FT (15 M)
BETWEEN THE POLE SAW AND ANY
ELECTRICAL LINE CARRYING LIVE
CURRENT OR BRANCH CONTACTING
AN ELECTRICAL LINE. BEFORE
WORKING CLOSER THAN 50 FT (15 M),
CONTACT ELECTRIC UTILITY AND
MAKE SURETHE CURRENT IS TURNED
OFF (FIG. 30).
AD 0414 -F/N 563397
21