Work Area; Electrical Safety; Important Safety Information - Skil RAS800 Instrucciones De Funcionamiento Y Seguridad

IMPORTANT SAFETY
INFORMATION . . . . . . . . . . . . . . . . . . .2-6
Parts List . . . . . . . . . . . . . . . . . . . . . . . 7-9
below may result in serious personal injury.

Work Area

Keep your work area clean and well lit. Cluttered
benches and dark areas invite accidents.
Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases, or dust. Power tools
create sparks which may ignite the dust or fumes.
Keep bystanders, children, and visitors away
while operating a power tool. Distractions can
cause you to lose control.

Electrical Safety

Grounded tools must be plugged into an outlet
properly installed and grounded in accordance
with all codes and ordinances. Never remove
the grounding prong or modify the plug in any
way. Do not use any adaptor plugs. Check with
a qualified electrician if you are in doubt as to
whether the outlet is properly grounded. If the
tools should electrically malfunction or break down,
grounding provides a low resistance path to carry
electricity away from the user. Improper grounding
can shock, burn, or electrocute. Grounded tools
are equipped with three-conductor cord and three-
prong-type plugs. Before plugging in the tool, be
certain the outlet voltage supplied is within the
voltage marked on the nameplate. Do not use
"AC only" rated tools with a DC power supply.
Double-insulated tools are equipped with a
polarized plug (one blade is wider than the
other). This plug will fit in a polarized outlet
only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install a
polarized outlet. Do not change the plug in any
way. Double Insulation
the three-wire grounded power cord and grounded
power supply system. Before plugging in the tool,
be certain the outlet voltage supplied is within the
voltage marked on the nameplate. Do not use "AC
only" rated tools with a DC power supply.
Table of Contents
Power Tool Safety Rules
Read and understand the tool manual and these instructions for the
use of this table with your router. Failure to follow all instructions listed
SAVE THESE INSTRUCTIONS
eliminates the need for
Router Table Setup . . . . . . . . . . . . . 10-15
Router Table Operation. . . . . . . . . . 16-28
Avoid body contact with grounded surfaces
such as pipes, radiators, ranges, and
refrigerators. There is an increased risk of electric
shock if your body is grounded. If operating the
power tool in damp locations is unavoidable, a
Ground Fault Circuit Interrupter must be used to
supply the power to your tool. Electriciansʼ rubber
gloves and footwear will further enhance your
personal safety.
Donʼt expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
Do not abuse the cord. Never use the cord to
carry the tools or pull the plug from an outlet.
Keep cord away from heat, oil, sharp edges,
or moving parts. Replace damaged cords
immediately. Damaged cords increase the risk
of electric shock.
When operating a power tool outside, use an
outdoor extension cord marked "W-A" or "W."
These cords are rated for outdoor use and reduce
the risk of electric shock. Refer to "Important
Information About Extension Cords" in your router
table manual.
2