Skil RAS800 Instrucciones De Funcionamiento Y Seguridad página 28

Router Table Operation
USING A MITER GAUGE (Fig. 32)
FIG. 32
The miter gauge slot will accommodate most
stationary table saw miter gauges that
measure 3/4" wide x 3/8" deep.
MITER
GAUGE
NOTE: For ALL routing operations requiring
the use of the miter gauge with the fence, BE
SURE to align the fence using the scales on
the top of the router table before making any
cuts. Miters can be cut by loosening the knob
on the protractor head, turning the protractor
head up to 60° in either direction, and
retightening the protractor head knob.
Guard not shown for clarity
Make a test pass with a scrap piece of wood
before making a cut to be sure the fence is
properly aligned. Adjust as required and fasten
the fence securely before making the cut.
28