Descargar Imprimir esta página

Craftsman 139.30437 Manual Del Propietário página 32

Ocultar thumbs Ver también para 139.30437:

Publicidad

Idiomas disponibles

Idiomas disponibles

Motion-DetectingControlPanel Setup
Motion
Sensor
Switch
LEARN Button _
LOCK Button
1 Minute
TTC LED
5 Minute
TTC LED
10 Minute
J
TTC LED
0
TIME
TO
CLOSE
Command LED
NOTE: If the command LED is
continuously blinking, the Lock feature
needs to be deactivated.
ON
J
Button
OFF
I
Button
HOLD OPEN
Button
LIGHT Button
-_.
Motion
Sensor
TIMER-TO-CLOSE (TTC)
NOTE:DO NOT enable TTCif operating a one-piece door. TTCis
to be used ONLYwith sectional doors.
Activate:
Press and hold the ON button until one of the TTC LEDs light up.
Then press the ON button again to cycle through the time interval
options (the corresponding TTC LEDwill light for each time
interval). The garage door opener light bulbs will blink as
confirmation.
Deactivate:
Press and hold the OFFbutton until all TTC LEDs turn off and a
beep is heard from the motor unit.
Temporarily hold door open (suspendTTC):
Press and releasethe HOLDOPENbutton. Press the HOLD OPEN
button again to resume normal TTCoperation.
LOCK
Activate:
Press and hold the LOCKbutton for 2 seconds. The command
LEDwill flash as long as the lock feature is activated and your
handheld remote control will not operate your door at this time.
Deactivate:
Press and hold the LOCKbutton again for 2 seconds. The
command LEDwill stop flashing and normal operation will
resume.
LIGHT
TOchangethe amount of time the garage door opener lights
will stay on:
Press and hold the LOCKbutton until the garage door opener
lights flash.* The time interval is indicated by the number of
flashes.
1
1 Y_Minutes
2
2 Y_Minutes
3
3 Y_Minutes
4
4 Y_Minutes
To cycle through the time intervals repeat the step above.
LIGHT FEATURE
Deactivate:
Press and hold the LIGHT button until the garage door opener
lights turn on, then off again.*
Activate:
Start with the garage door opener lights on. Press and hold the
LIGHT button until the garage door opener lights turn off, then on
again.*
MOTIONSENSOR
Activate/Deactivate:
Slide the motion sensor switch ON or OFF.
* Approximately 10 seconds
32

Publicidad

loading