Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING - YOUR RESPONSIBILITY:
understand and follow the warnings and instructions in this manual and on the machine.
NOTE: Not all safety labels may apply to your Yard Vacuum.
SECTION 2: ASSEMBLING YOUR YARD VACUUM
This unit is shipped without gasoline or oil
IMPORTANT:
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: Reference to right or left hand side of the Yard
Vacuum is observed from the operating position.
Removing Unit From Carton
•
Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
•
Remove loose parts if included with unit (i.e.,
operator's manual, etc.)
•
Cut along corners, lay carton down flat, and remove
packing material.
•
Roll or slide unit out of carton and check carton
thoroughly for loose parts.
Loose Parts In Carton
•
Handle Assembly
•
Bag
•
Blower Chute (If Equipped)
•
Hose Assembly
Disconnecting Spark Plug Wire
Before setting up your Yard Vacuum, disconnect the
spark plug wire from the spark plug and ground to a
stud on the engine.
(See Figure 1)
Restrict the use of this power machine to persons who read,
Blower Chute
Upper
Handle
Wing
Rope
Nuts
Guide
Lower
Handle
Hose
Assembly
5
Bag
Figure 1
Publicidad
