SETUP
INSTALLING /CHANGING ALKALINE BATTERIES :
The EVOLUTION uses advanced technology that prolongs battery
TM
life through efficient power use. With normal use of four (4) hours
per day at any setting, your batteries should last a minimum of 2
years.
Two (2) AA alkaline batteries are packaged in the box with your
EVOLUTION . Follow these easy steps to install or change
TM
batteries when needed:
STEP 1: While holding the unit in one hand, remove the Phillips screw [A] that holds the battery
door in place, then gently press down on the battery door with your thumb and open
the hinge door away from the EVOLUTION label [Figs. C1 and C2].
STEP 2: Drop the batteries into the slot, making sure they are inserted in the proper
direction as indicated by the (+) and (-) symbols [Fig. C 3] .
STEP 3: Rotate the door cover back in place until a "click" is heard.
Reinstall the Phillips screw [A] that was removed in Step 1, do not overtighten.
NOTE: The EVOLUTION
positive terminal to prevent battery oxidation. If it has not already been removed by
your Home Care Provider, be sure to remove the seal before using the unit for the first
t ime.
MONITORING BATTERY ENERGY LEVEL:
The EVOLUTION is equipped with a low battery indicator light that alerts you when a battery change is needed.
TM
The following signal will be displayed as your batteries become depleted:
Blinking red light: Low Battery energy level. Replace batteries.
Disposal of Batteries: Do not dispose of used batteries in the household waste. Contact a public waste disposal
authority for proper disposal instructions.
TM
TM
is packaged with batteries inside. A special seal is used at the
C1
C2
C3
13