Inserting The Tool - Sunitec MAB 825 Instrucciones De Manejo

Steel of low thickness
NF metals or workpieces with an uneven surface

Inserting the tool

CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
MAB 825/845
When drilling in steel of low thickness, an additional steel plate
(minimum dimensions 100 x 200 x 20 mm) must be placed under
the workpiece. Secure the steel plate to prevent it from falling.
A special holding device must be used when drilling in NF metals
or in workpieces with an uneven surface.
NOTE
► BDS offers special clamping devices for tubes and non-
magnetic materials in its range of accessories.
The machine is equipped with an MK tool mounting. Depending
on the type of tool to be used, corresponding drill chucks, quick-
clamping systems or adapters must be employed.
Tool
Tool with
MK3 taper
Tool with
MK2 taper
Tools with
32 mm Weldon shank
Tools with
19 mm Weldon shank
Tools with
straight shank
Thread taps
Tool mounting to be used
Insert the tool directly into the morse
taper (3).
Use MK3:2 adapter sleeve (available as an
accessory).
Use MK3 industrial arbor/32 mm Wel-
don (G).
Use KEYLESS quick-change drill chuck
system (A).
Use drill chuck with MK3/B16 tapered man-
drel (available as an accessory).
Use the appropriate adapter for thread
taps (available as an accessory).
Preparations
47