Rotating Mechanism (Mab 845 Only); Drilling With The Machine - Sunitec MAB 825 Instrucciones De Manejo

Operation

Rotating mechanism (MAB 845 only)

Drilling with the machine

Drilling with twist drills
CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
54
In order to permit optimum alignment even in difficult positions,
the model MAB 845 is additionally equipped with a rotating
mechanism. It allows the upper part of the machine to be rotated
by 30° to both sides and by 20 mm forwards and backwards with
the magnetic foot engaged.
Loosen the locking device of the rotating mechanism (13).
‹
Position the upper part of the machine laterally and longitu-
‹
dinally.
Lock the rotating mechanism again.
‹
CAUTION
► Operate the machine only with the rotating mechanism
locked.
Proceed as follows when drilling with twist drills:
Push twist drills with MK taper from below into the morse
‹
taper (3) of the machine.
Push twist drills with straight shank into the drill chuck after
‹
fitting the drill chuck.
Position the machine at the working location, align it and
‹
switch on the magnetic clamps.
Select the appropriate speed and switch on the machine.
‹
NOTE
Observe the following instructions when drilling with twist drills:
► Under high pressure, the drill can glow out and the machine
can be overloaded.
► Pay attention to a regular chip discharge. With larger drilling
depths, break the chip.
MAB 825/845