Intended Use; Liability Disclaimer - Sunitec MAB 825 Instrucciones De Manejo

Instructions for use

Intended use

Liability disclaimer

CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
36
The machine is intended solely for drilling operations in magnetic
and non-magnetic metals, and for cutting threads, countersinking
and reaming within the limits specified in the technical data.
Use in any other or further way is not considered an intended use.
WARNING
Danger from use for other than the intended purpose!
If not used for its intended purpose and/or used in any other
way, the machine may be or become a source of danger.
► Use the machine only for its intended purpose.
► Observe the procedures described in these operating
instructions.
No claims of any kind will be accepted for damage or injury result-
ing from use of the machine for other than its intended purpose.
The risk has to be borne solely by the machine owner.
NOTE
► If used commercially, pay attention to compliance with the
accident prevention regulations and the Safety at Work
Ordinance.
All technical information, data and instructions for commissioning,
operation and care of the machine contained in these operating
instructions represent the latest status at the time of printing.
The manufacturer assumes no liability for damage or injury result-
ing from failure to observe the operating instructions, use for other
than the intended purpose, unprofessional repairs, unauthorised
modifications or use of non-approved spare parts and accesso-
ries, tools and lubricants.
MAB 825/845