Bühler technologies GAS 222.20-HT Guía Rápida página 10

GAS 222.20-HT, GAS 222.20-HT-OW-OR
5.2.1 Menu Navigation Overview
Temperature and status display
____
Display
The probe temperature is indicated in 0.5°C increments. Press the Enter key to access the main menu.
Current temperature
The temperature can be displayed in Celsius or Fahrenheit.
Main menu
Display
Probe controller
Exit
Exit main menu
6 Maintenance
Always observe the applicable safety- and operating regula-
tions when performing any type of maintenance. Please refer
to the original operator's manual on the included CD or online
at www.buehler-technologies.com for maintenance informa-
tion.
7 Service and Repair
Please refer to the original operator's manual on the included
CD or online at www.buehler-technologies.com for a detailed
description of the unit including information on
troubleshooting and repair.
8 Disposal
The applicable national laws must be observed when dispos-
ing of the products. Disposal must not result in a danger to
health and environment.
The crossed out wheelie bin symbol on Bühler Technolo-
gies GmbH electrical and electronic products indicates special
disposal notices within the European Union (EU).
The crossed out wheelie bin symbol indicates
the electric and electronic products bearing
the symbol must be disposed of separate
from household waste. They must be properly
disposed of as waste electrical and electronic
equipment.
Bühler Technologies GmbH will gladly dis-
pose of your device bearing this mark. Please
send your device to the address below for this
purpose.
10 Bühler Technologies GmbH
Submenu
Prob
tEMP
Temperature
Target temperature
ALAr
Alarm
Alarm hysteresis
Exit E
Exit submenu
E
Adjust value
Setting range
stores the value
wait 4s: do not save
Setting the probe temperature
____
Selection menu
within the range:
Probe temperature
50 °C...280 °C / 122 °F...536 °F
___
Selection menu Setting the alarm hysteresis
within the range: ±5°C...±30°C
Setting range
We are obligated by law to protect our employees from haz-
ards posed by contaminated devices. Therefore please under-
stand that we can only dispose of your waste equipment if the
device is free from any aggressive, corrosive or other operat-
ing fluids dangerous to health or environment. Please com-
plete the "RMA Form and Decontamination Statement", avail-
able on our website, for every waste electrical and electronic
equipment. The form must be applied to the packaging so it is
visible from the outside.
Please return waste electrical and electronic equipment to the
following address:
Bühler Technologies GmbH
WEEE
Harkortstr. 29
40880 Ratingen
Germany
Please also observe data protection regulations and remem-
ber you are personally responsible for the returned waste
equipment not bearing any personal data. Therefore please
be sure to delete your personal data before returning your
waste equipment.
BX460026 ◦ 12/2023