Hama 00185861 Instrucciones De Uso página 5

• The product is intended only for use inside buildings.
• Route all cables so that there is no risk of tripping.
• Do not bend or crush the cable.
• Always pull directly on the plug when disconnecting the cable,
never on the cable itself.
Warning - Batteries
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly. Failure to do so
could result in the batteries leaking or exploding.
• Only use batteries that match the speci ed type. Keep the
instructions for the correct choice of batteries included with
the operating instructions of devices safe for future reference.
• Before you insert the batteries, clean the battery contacts and
the polarity contacts.
• Do not allow children to change batteries without supervision.
• Replace all the batteries in a set at the same time.
• Do not mix old and new batteries, or batteries of different
types or from different manufacturers.
• Remove the batteries from products that are not being used
for an extended period (unless these are being kept ready for
an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries or heat them up.
• Never open, damage or swallow batteries or allow them to
enter the environment. They can contain toxic, environmentally
harmful heavy metals.
• Remove spent batteries from the product and dispose of them
without delay.
Warning - Batteries
• Avoid storing, charging and using in extreme temperatures
and at extremely low atmospheric pressures (such as at high
altitudes).
• Ensure that batteries with damaged housings
do not come into contact with water.
• Keep batteries out of the reach of children.
Risk of electric shock
• Do not open the device or continue to operate it if it becomes
damaged.
• Do not use the product if the
AC adapter, the adapter cable or the mains cable are
damaged.
• Do not attempt to service or repair the product yourself. Leave
any and all service work to quali ed experts.
5. Setup
Warning
• Only operate the product from an approved socket that is
connected to the public power supply. The socket must be
installed close to the product and must be easily accessible.
• Disconnect the product from the power supply using the On/
Off switch – if this is not available, unplug the power cord
from the socket.
• If using a multi-socket power strip, make sure that the total
power consumption of all connected devices does not exceed
the socket strip's maximum throughput rating.
• If you will not be using the product for a prolonged period,
disconnect it from mains power.
5.1 Inserting batteries / power supply
Measuring station
• Remove the protective lm from the display.
• Open the battery compartment (38) and remove the contact
breaker.
• Then close the battery compartment cover.
Note
Please remember, during commissioning, to always insert the
batteries into the measuring station rst.
Base station
• Remove the protective lm from the display.
• Then connect the enclosed power supply unit to the power supply
unit connection socket on the side (30).
• Connect the weather station's power supply unit to a correctly
installed mains socket.
• Alternatively, you can also insert 2 x AA batteries. However the
display switches to unilluminated standby mode after 10 seconds
with battery operation.
5.2 Changing batteries
Measuring station
• If the battery warning symbol (16) appears next to the outdoor
ambient humidity, replace the batteries in the measuring station
with two new batteries.
• Open the battery compartment (38), remove and dispose of the
spent batteries and insert two new AA batteries, observing the
correct polarity. Then close the battery compartment cover.
Base station
• If the battery warning symbol
ambient humidity, replace the batteries in the measuring station
with two new batteries.
• Open the battery compartment (33), remove and dispose of the
spent batteries and insert two new AA batteries, observing the
correct polarity. Then close the battery compartment cover (33).
(22) appears next to the indoor
5