cecotec CONGA 1990 CONNECTED X Manual De Instrucciones página 22

ENGLISH
Warning
Remove all objects around the robot such as clothing, papers, cables, curtains or other fragile
objects. Fig. 15
If the area to be cleaned has a balcony or stairs, a physical barrier must be placed in order to
prevent product damage and ensure safe operation. Fig. 16
Direct exposure to sunlight or great light contrasts may affect to the correct operating of the
sensors. If this happens and the robot stops, change it to a new location for it to startoperating
again. Fig. 17
1. Place the charging base against the wall and leave a minimum free space of:
- 2 metres to the front.
- 1 metre to each side. Fig. 18
2. Connect the charging base to a power supply. Wind and store the remaining cord in the
lower part of the charging base to avoid accidents. Fig. 19
3. Install both side brushes in their corresponding slots, located on the robot's bottom part.
Press until it clicks to make sure they are properly fixed. Fig. 20
4. Press the power switch located on the bottom part of the robot. Make sure the power
switch is turned On. Fig. 21
5. Place the robot on the charging base and make sure the charging terminals on the robot
match with those of the charging base. Once the robot is properly placed, it will beep once
and the power button will light up If the light is oscillating orange, it means the battery is
not completely charged. To ensure maximum cleaning time, wait until the light switches
to steady blue. This will indicate the battery is fully charged and that the robot is ready to
clean. Fig. 22
3. OPERATION
Start cleaning
Hold down the power button on the robot to turn the robot on.
Press the power button on the robot or select it in the app to start cleaning.
Note
If the robot runs out of battery during cleaning, it will automatically return to the charging
base. Once the battery is fully charged, the robot can start a new cleaning cycle.
Warning
If there is no good access to the charging base, the robot will not be able to return to its charging
position. In that case, once the robot has stopped, take it manually to the charging base.
42
Pause
Press the power button on the robot or select it in the app to pause the cleaning process.
Press the power button on the robot or select it in the app to resume the cleaning process. Fig.
23
Return to the charging base
Press the return home button on the robot or in the app to send the robot to the charge base.
Turn off
Hold down the power button to turn the robot off. Fig. 24
Warning
The robot vacuum cleaner has a power switch located on its main body. If the robot is not going
to be used for long periods of time, it is suggested to switch it off. If the robot is switched off, it
will restore factory default settings as a safety measure. If we want the robot to work in time
programming mode, the switch must always be in the on position, otherwise we will have to
carry out a new programming from the app.
Cleaning modes
- This robot includes different modes and functions that can be activated via the app.
Automatic mode
- Press the power button for the robot to start Auto cleaning mode.
- The robot will clean the whole surface, edges, around objects such as tables, chairs etc.
Once it starts running out of battery, it will return to the charging base. Fig. 25
Scrubbing mode
- Attach the mop cloth to the water tank and fill the tank with water.
- Take the dust tank out.
- Install the water tank in the robot and turn it on. Fig. 26
- You can select the scrubbing level via the app: high, medium or low.
- Once the desired scrubbing level has been selected from the app, the robot will perform
the All in One functionality to vacuum, scrub and sweep simultaneously thanks to its mixed
tank.
- Note: If you want to sweep the floor, skip the water-filling step.
- To ensure perfect scrubbing from the start, it is suggested to dampen the mop cloth evenly
with water before use.
Spot mode
- The robot will carry out an intense cleaning of a specific area when this mode is activated.
The robot will start cleaning at a specific point and will move outwards performing spiral
ENGLISH
43